ESR6670 is a 3G-enabled 2T2R Wireless-N Router that delivers up to 3x faster speed (300Mbps) and 3x extended coverage than 802.11g devices. With Extreme Session Support (19000 Sessions) users are able to experience the unprecedented performance and smooth network services.
This product supports 3G data cards from HuaWei, OPTION, Sierra, BandLuxe and SIMCOM with standards covering WCDMA (HSDPA), CDMA2000 & TD-SCDMA. It is built-in with USB for easy and flexible plug-and-play interface for 3G cards.
ESR6670 supports home network with superior throughput and performance and unparalleled wireless range. With easy to use on the WPS function, it helps users to connect to wireless device with just one push button.
There's also a built-in 2-port full-duplex 10/100 Fast Switch to connect your wired-Ethernet devices together. The Router function ties it all together and lets your whole network shares a high-speed cable or DSL Internet connection.
Router And Gateway
Topology | Infrastructure |
Operation Mode | AP / Router / WDS |
LAN |
DHCP Server Static Routing Table |
WAN |
PPTP PPPoE Static IP DHCP Client Clone MAC |
Router |
NAT/ NAPT Static Routing Dynamic Route Virtual server mapping IP address mapping Port Forwarding Port Triggering Special application ALG(Application Layer Gateway) support (RTP/RTSP, AOL, FTP, ICMP, WMP/MMS, NetMeeting, SIP) DNS Relay DDNS Time Zone(NTP client) |
Firewall |
Blocking Ping DoS(Blocking Ping, Port scan, Sync Flood) MAC / IP Filtering ICMP Blocking SPI (Stateful Packet Inspection) DMZ (Demilitarized Zone) Host Policy Based Parental Controls Port Range / Service Filtering Internet Domain Restriction URL Filtering |
VPN | VPN pass-through (PPTP, L2TP, IPSEC) |
Wireless |
Power saving(Green technology) Multiple SSID 64/128 bit WEP Encryption WPA Personal (WPA-PSK using TKIP or AES) WPA Enterprise (WPA-EAP using TKIP) 802.1x Authenticator Hide SSID in beacons Wi-Fi Protection Setup (WPS) WDS ACL control Best channel selection Speed/Bandwidth monitor |
QoS |
WMM Application base Priority Queue Bandwidth Allocation |
Management | |
Configuration | Web-based configuration (HTTP) |
Firmware Upgrade |
Via webpage upgrade Auto recovery once firmware upgrade fail |
Administrator Setting | Administrator password change |
Reset Setting |
Reboot Reset to Factory Default |
System monitoring | Speed and Bandwidth monitoring |
Scheduling |
Enable Firewall Enable power saving |
Easy access | User can type model name and access the main page. |
Install wizard | Guide user to set-up Router smoothly |
Technical Specifications
Hardware Specifications | |
Memory | 32MB SDRAM |
Flash | 4MB |
Physical Interface |
WAN: 1 * 10/100 Fast Ethernet RJ-45 LAN: 2 * 10/100 Fast Ethernet RJ-45 Rest button Power Jack WPS (WiFi Protected Setup) USB (for 3G data card) |
LEDs Status |
Power Status WAN (Internet connection) 10/100Mbps LAN1 & LAN2 WLAN(Wireless connection) 3G networks |
Power Requirements |
Power Supply: 200 to 240 VDC ± 10% (ETSI) 100 to 120 VDC ± 10% (FCC) Device: 12V/1.25A |
Top Panel (LED status) | |
Power | 1 ( On-> orange Test/reset default->blink) |
3G | 1 ( Link-> blue on) |
WAN | 1 ( Link-> blue on, traffic->blink) |
Internet | 1 ( Link-> blue on) |
WLAN | 1 ( Link-> blue on, traffic->blink) |
LAN1 | 1 ( Link-> blue on, traffic->blink) |
LAN2 | 1 ( Link-> blue on, traffic->blink) |
Rear Panel (Interface) | |
Antenna | Detachable SMA |
Environment & Mechanical | |
Temperature Range | 0 to 45° C - Operating, -10 to 70 ° C - Storage |
Humidity (non-condensing) | 15%~95% typical |
Dimensions | 125mm (L) x 98mm (W) x 25mm (H) |