The GS-4210-16P2S is an ideal Gigabit PoE Switch which provides a cost-effective advantage to local area network and is widely accepted in the SMB office network.
8-Port 10/100/1000BASE-T Gigabit RJ45 copper with 8-Port IEEE 802.3at/af PoE Injector (Port-1 to Port-8)
2 100/1000BASE-X mini-GBIC/SFP ports
RJ45 console interface for switch basic management and setup
Power over Ethernet
Complies with IEEE 802.3at Power over Ethernet Plus, end-span PSE
Backward compatible with IEEE 802.3af Power over Ethernet
Up to 8 ports of IEEE 802.3af/802.3at devices powered
Supports PoE power up to 30 watts for each PoE port
Auto detects powered device (PD)
Circuit protection prevents power interference between ports
Remote power feeding up to 100 meters in standard mode and 250m in extend mode
PoE management
Per port PoE function enable/disable
PoE port power feeding priority
Per PoE port power allocation
PD classification detection
PD alive check
PoE schedule
Layer 2 Features
Prevents packet loss with back pressure (half-duplex) and IEEE 802.3x pause frame flow control (full-duplex)
High performance Store and Forward architecture, broadcast storm control, runt/CRC filtering eliminates erroneous packets to optimize the network bandwidth
Supports VLAN
IEEE 802.1Q tagged VLAN
Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
Protocol VLAN
Voice VLAN
Private VLAN (Protected port)
Management VLAN
GVRP
Supports Spanning Tree Protocol
STP (Spanning Tree Protocol)
RSTP (Rapid Spanning Tree Protocol)
MSTP (Multiple Spanning Tree Protocol)
STP BPDU Guard, BPDU Filtering and BPDU Forwarding
Supports Link Aggregation
IEEE 802.3ad Link Aggregation Control Protocol (LACP)
Cisco ether-channel (static trunk)
Maximum 1 trunk group, up to 2 ports per trunk group
Provides port mirror (many-to-1)
Loop protection to avoid broadcast loops
Supports ERPS (Ethernet Ring Protection Switching)
Quality of Service
Ingress/Egress Rate Limit per port bandwidth control
Storm Control support
Broadcast/Unknown-Unicast/Unknown-Multicast
Traffic classification
IEEE 802.1p CoS
TOS/DSCP/IP Precedence of IPv4/IPv6 packets
Strict priority and Weighted Round Robin (WRR) CoS policies
Complies with IEEE 802.3at Power over Ethernet end-span PSE
Up to 16 ports of IEEE 802.3af/802.3at devices powered (ports 1~16)
Supports PoE power up to 32 watts for each PoE port, with a total PoE budget of 185W.
Each port supports 54V DC power to PoE powered device
Auto detects powered device (PD)
Supports PD alive function
Circuit protection prevents power interference between ports
Remote power feeding up to 100m in standard mode with 250m in extend mode
Switching
Hardware-based 10/100/1000Mbps auto-negotiation and auto MDI/MDI-X
Supports IEEE 802.3x flow control in full-duplex mode and backpressure in half-duplex mode
Integrates address look-up engine, supporting 8K absolute MAC addresses
9K jumbo frame supports all speeds (10/100/1000Mbps)
Hardware DIP switch for Standard, VLAN and Extend mode selection;
VLAN mode: Ports 1 to 16 cannot communicate with each other, but can communicate with the uplink ports 17 to 18 and SFP ports 19 to 20
Extend mode: Ports1 to 8 have data rate of 10Mbps. The farthest transmission distance of up to 250 meters and all ports can communicate with each other.
VLAN mode is to isolate ports to prevent broadcast storm and defend DHCP spoofing
Automatic address learning and address aging
Supports Energy-Efficient Ethernet (EEE) function (IEEE 802.3az)
Hardware
12-inch desktop size, 1U height
LED indicators for system power, per port PoE ready and PoE activity, speed, Link/Act
1 silent fan to provide stable and efficient power performance
Supports contact discharge of ±6KV DC and air distance discharge of ±8KV DC for Ethernet ESD protection